[lxc-users] set "lxc.aa_allow_incomplete = 1" - where do I add it for lxd?

[Serge Hallyn]

Quoting Tomasz Chmielewski (mangoo at wpkg.org):
> On 2015-10-27 23:36, Serge Hallyn wrote:
> 
> >>Same "lxc config set containername", i.e.:
> >>
> >>lxc config set x1 raw.lxc "lxc.network.ipv4 = 10.0.12.2/24"
> >>lxc config set x1 raw.lxc "lxc.network.ipv4.gateway = 10.0.12.1"
> >>lxc config set x1 raw.lxc "lxc.network.ipv6 = 1111:2222:3333:4444::55"
> >>lxc config set x1 raw.lxc "lxc.network.ipv6.gateway =
> >>1111:2345:6789:aaaa::2"
> >>
> >>Or is there some other, more recommended way?
> >
> >Can you show fully what you want to do?  Are you aiming for a
> >routed config, or are you moidfying a bridged nic device?
> 
> The above is mixed: routed IPv4 and bridged IPv6 config.
> 
> But it doesn't matter if it's bridged or routed - all I want to do is:
> 
> - to set static IPv4 and IPv6 addresses, without doing so in the
> container (works with lxc),
> 
> - be sure lxd does not hang if I supply something incompatible in CLI :)

Yeah, that one is bad!  Can you open an issue for that?