[Lxc-users] Bad checksums and lost packets with macvlan on dummy

[Daniel Lezcano]

On 03/12/2011 10:59 PM, Daniel Lezcano wrote:
>
> Hi Patrick,
>
> I noticed another problem with the macvlan driver.
>
> In the function dev_forward_skb the test always succeed in the second
> condition making the packet to be dropped.
>
> ...
>
>       if (unlikely(!(dev->flags&  IFF_UP) ||
>                (skb->len>  (dev->mtu + dev->hard_header_len + VLAN_HLEN)))) {
>
> ...
>
> When tracing I have the following values:
>
> skb->len = 2962
> and
> dev->mtu + dev->hard_header_len + VLAN_HLEN = 1518
>
> Do you have any idea where that could be come from ?

Disabling TSO solves the problem. Is it possible the packets are not 
fragmented to the mtu size as it is supposed to be done by the lower 
device but as we are in bridge mode, we dev_forward_skb and the check is 
expecting the packet to be mtu-compliant ?


> On 03/08/2011 03:41 PM, Patrick McHardy wrote:
>> Am 02.03.2011 19:33, schrieb Daniel Lezcano:
>>> On 03/02/2011 07:03 PM, Patrick McHardy wrote:
>>>> Am 02.03.2011 17:03, schrieb Daniel Lezcano:
>>>>> On 03/02/2011 12:03 PM, Patrick McHardy wrote:
>>>>>> Am 01.03.2011 21:04, schrieb Daniel Lezcano:
>>>>>>> On 03/01/2011 05:51 PM, Patrick McHardy wrote:
>>>>>>>>> Patrick, do you have any suggestions to fix this ?
>>>>>>>> Since the frames are only looped back locally, I suppose the easiest
>>>>>>>> fix would be to mark them with CHECKSUM_UNNECESSARY. Alternatively
>>>>>>>> we need to complete the checksum manually, similar to what
>>>>>>>> dev_hard_start_xmit() does.
>>>>>>> That sounds very simple to fix, maybe too much simple :)
>>>>>>>
>>>>>>> I did the following change:
>>>>>>>
>>>>>>> --- linux-next.orig/drivers/net/macvlan.c
>>>>>>> +++ linux-next/drivers/net/macvlan.c
>>>>>>> @@ -222,6 +222,7 @@ static int macvlan_queue_xmit(struct sk_
>>>>>>>
>>>>>>>             if (vlan->mode == MACVLAN_MODE_BRIDGE) {
>>>>>>>                     const struct ethhdr *eth = (void *)skb->data;
>>>>>>> +               skb->ip_summed = CHECKSUM_UNNECESSARY;
>>>>>>>
>>>>>>>                     /* send to other bridge ports directly */
>>>>>>>                     if (is_multicast_ether_addr(eth->h_dest)) {
>>>>>>>
>>>>>>>
>>>>>>> and that fixed the problem. Do you think it is acceptable ?
>>>>>> The only problem I see is if the packets are bridged to a
>>>>>> different networking device (or redirected using the mirred
>>>>>> action), in this case the checksum will not be completed.
>>>>>> This would be a very strange setup though and probably wouldn't
>>>>>> be using dummy as lower device, so I'm not sure we have to
>>>>>> worry about this case.
>>>>> I am not sure to get it, do you say the patch is correct ?
>>>> Its correct with a short-coming that doesn't seem to matter.
>>>>
>>>>> If my understanding is correct, the packet will be flagged
>>>>> CHECKSUM_UNNECESSARY only for the macvlan devices, right ?
>>>> Only for packets bridged between macvlan devices. A setup like
>>>> the following would cause problems:
>>>>
>>>>                            br0
>>>>                             |
>>>>                       .----------.
>>>>                       |          |
>>>> macvlan0    macvlan1    eth0
>>>>       |               |
>>>>        -------.-------
>>>>        dummy0
>>>>
>>>> In this case packets sent from macvlan0 will show up on
>>>> eth0 with incorrect setups. However this setup doesn't
>>>> seem realistic to me, you would simply use eth0 instead
>>>> of dummy0.
>>> Ok, I understand. thanks for the clarification.
>>>
>>>>> By the way, this problem occurs for any lower device with offloading
>>>>> capabilities with a macvlan port in bridge mode.
>>>> True. This doesn't affect outgoing packets since their checksum
>>>> will be completed in dev_hard_start_xmit(), but it affects
>>>> packets bridged between macvlans.
>>> One last question. In the case of broadcast packets with maclvan in
>>> bridge mode.
>>> We will have the packets going through each macvlan port and also to the
>>> lower-device, right ?
>>> For the latter, don't we have a problem if the packet is flagged
>>> CHECKSUM_UNNECESSARY ?
>>>
>>> Shouldn't we restore the ip_summed field before sending through
>>> dev_queue_xmit ?
>> Yes, that seems correct in order to have dev_hard_start_xmit() complete
>> the checksum if necessary.
>
>
>
> ------------------------------------------------------------------------------
> Colocation vs. Managed Hosting
> A question and answer guide to determining the best fit
> for your organization - today and in the future.
> http://p.sf.net/sfu/internap-sfd2d
> _______________________________________________
> Lxc-users mailing list
> Lxc-users at lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/lxc-users